CUSTOM AMP PANEL PRICING

BNP HOMEARTWORKMATERIALSPRICINGFAQSHIPPINGORDER FORM 

Based on total square inches of material used makes pricing for the amp panels very simple. 

If you have selected a standard/stocked plastic material, all of the finished sized holes are included in the square inch price of the material.  There are no additional charges for special shaped holes in the plastics. 

If you have selected a reverse plastic material, we provide backfilling of the engraved graphics in standard black or white paint.  Any special colors that you may want are your responsibility.  Custom colors are readily available at any local craft store and can be applied easily applied with a small paint brush.  You must however use ACRYLIC based paints.

If you have selected a metal, the price of the panel is increased by .30 for each finished size round hole that we punch out.  A/C plug knockouts are an additional $2.00 per hole.

To calculate the total square inches of your panel, take the height x length and round up to the next whole number then multiply your total by:

FRONT ENGRAVED PLASTIC:  .63/SQUARE INCH

REVERSE ENGRAVED PLASTIC:  .70/SQUARE INCH

LASER MARKED ALUMINUM:  .80/SQUARE INCH

LASER MARKED ALUMAMARK (GOLD OR SILVER):  .95/SQUARE INCH

DOUBLE SIDED TAPE APPLIED TO ANY MATERIAL:  .06/SQUARE INCH

NUMBER OF FINISHED SIZED HOLES IN METAL (ROUND ONLY) X .30/HOLE

NUMBER OF FINISHED SIZED HOLES (OTHER THAN ROUND) X $2.00

SPECIAL ORDER PLASTICS ADD $40.00

ARTWORK SETUP COST $30.00 PER PANEL

SHIPPING IS DONE VIA US PRIORITY MAIL

 

BNP Lasers

124 Edgewood Drive

Washington, PA  15301

724-222-5446  (office) 

CONTACT US..!